Pins for Inspection Jigs / GO and NO-GO / Reversible

Part number:

Still undefined. 4 possible part numbers found.

Outline drawing and specifications table
Part number list
More Information

Outline drawing and specifications table

Dimensional Drawing

KJPRGN

[ ! ]1

[ ! ]2

[ ! ]1

* Tolerance, Effective Hardness Range

[!] Handles and pins may be joined with an adhesive. Note that heat or strong force may cause separation.
[!] 1. When L = 50 and G, N < 3, G side is shaped as shown on the left. (Same for N side)
[ ! ] 2. Marks may remain on the bent sections.

Ordering Example

Part Number (TYPE·D)	—	G	—	N
KJPRGN10	—	G2.00	—	N4.00

Specification Table

Part Number		0.01 mm Increments		L
Type	D	G	N (G < N)
KJPRGN	10	1.50 to 6.00		25
	10 L			50
	14	1.50 to 8.00		25
	14 L			50

Alterations

Part Number	—	G	—	N	—	(KH·STC·MH·CH)
KJPRGN10 KJPRGN14L	— —	G2.00 G4.00	— —	N4.00 N6.00	— —	KH CH

Alterations	Code	Spec.
	KH	Machines flats on the knurled head, and engraves G and N dimensions. Ordering Code KH
	MH	Adds M4 tapped hole for the wire chain on the handle. [ ! ] When combined with KH, the tapped hole is on a flat surface. [ NG ] Combination with CH is not available
Additional Surface Treatment (Black Oxide)	STC	Adds black oxide surface treatment. [ ! ] Applicable to pins only
Chain	CH	Loss-proof chain (length 600 mm) is attached to gauge body. [ ! ] Adds on a flat surface when combined with KH. [ NG ] Combination with MH is not available